Welcome to the Mensor Calibration Blog

In our blog you can expect informative articles on pressure and temperature calibration, testing and precision measurement. You will find solutions for your calibration requirements through our articles on industry specific applications, along with answers to common questions and a dialogue with experts.

All posts by Trisha Tripathi

Is a One-Point Calibration Sufficient?

05/16/2019
|

In calibrating pressure transducers and transmitters, a standard field practice is to perform a simple one-point calibration. This is performed at…

Read more

Long-term stability in silicon pressure transducers

02/28/2019
|

Long-term stability is one of the most important parameters that determine the overall measurement accuracy of a pressure sensor. Long-term…

Read more

The Evolution of a Deadweight Tester

10/11/2018
|

Deadweight testers, or pressure balances, have been around a long time and are the first instruments that come to mind when thinking of primary…

Read more

Contamination Prevention: How to Extend Life of Pneumatic Pressure Calibrators

03/29/2018
|

Pneumatic pressure calibrators and controllers are designed to operate in clean dry air or nitrogen, but are often subjected to particulate, water or…

Read more

Low Pressure Measurements: Calibration Problems and Solutions

03/29/2018
|

Low pressure differential and gauge calibrations require a calibration setup that is different as compared to its higher pressure counterparts.

Read more

Pressure Testing Intra-aortic Balloon Catheters

03/29/2018
|

The intra-aortic balloon pump (IABP) is a mechanical device that assists the human heart in pumping blood by decreasing myocardial oxygen demand and…

Read more

Calibrating Hospital Bed Pressure Sensors to Reduce Ulcers in Patients

03/29/2018
|

Patients who experience extended stays in the hospital often spend a good amount of time in a hospital bed. This prolonged non-ambulatory state can…

Read more